BUsiness

Methods to Set up Countertop Brackets

Sharing is caring!

Countertop brackets are an effective way to spice up the looks of your kitchen. Brackets that poke out of the wall are normally bland and unattractive, but countertop brackets can simply be very elaborate, nearly resembling real forged iron brackets of their ornamentation. Installing countertop brackets is probably one of the easiest home enhancements you are able to do, and when you have even probably the most fundamental of skills, you possibly can install these things in just a few hours or less. Some individuals advocate that you’ve your countertop brackets installed by knowledgeable, but so long as you might be careful, and take the time to measure accurately, there isn’t any reason why you should not be able to install them yourself. Just follow just a few simple guidelines to completing this project, and it is best to have it achieved with none effort at all.

Step 1 – Preparation

Before you being to make any holes for your countertop brackets, you’ll have to mark on the wall where you need them to go. There are two things that you will have to take notice of. The primary is the wall stud. You can locate this either by tapping along the wall till there is a change between hollow and in any other case, or you may use a stud finder, which is an electronic machine which will locate the studs for you. In addition, you must make sure that you may be installing the countertop brackets on a straight line. The simplest approach to do this is to mark where you need the primary bracket to be, after which use a spirit level to work out where the right angle is. Mark in pencil on the wall the place the holes ought to go.

Step 2 – Drill a Hole

The primary hole will must be drilled straight into the wall stud. Only go a sure size into the wall, maybe an inch or so using a very fine drill bit. The reason for this is that you’ll want to install plastic anchors which will preserve the screws on the wall, and never enable them to slide down, and you want to drill a hole which is slightly smaller than this anchor, so the wall holds it tightly.

Step three – Fitting the Anchor

After getting drilled the hole, screw or hammer your anchor into position. The anchor will be the system which is holding your bracket onto the wall, and in flip holding the countertop to the wall, so you’ll be able to see that it must be a good fit. You should buy a range of plastic anchors in different sizes, so just be sure you have chosen the one which will greatest hold your screw in place.

Step 4 – Fitting the Bracket

Now take the bracket, and place the screw hole over the anchor. Add a screw, and drive it into the anchor together with your screwdriver. Do not tighten it up but, but insert the entire brackets into the wall, after which go round screwing them all in tightly. Check that they’re straight, and then place your countertop over them.

If you beloved this article so you would like to collect more info concerning Heavy Duty Countertop Brackets generously visit our internet site.