BUsiness

Find out how to Build a Shelf Using Brackets

Sharing is caring!

Brackets are available in a myriad of shapes and sizes. Using brackets to assist and create a shelf allows the shelf to be coordinated with the room decor, be custom-sized, and be built by an intermediately skilled residence decor DIY-er. Several shelves, staggered on a wall, make a serious design statement. A shelf positioned above a door is a discovered-house storage resolution, and a series of cabinets running around a room’s perimeter, high on a wall, could make a lateral book case for a small library.

Step 1

Select brackets that will accommodate the chosen shelf. A typical shelf is 12 inches deep. This is the measurement from the front of the shelf to the wall. Brackets are basically “L” -formed; one leg of the L is hooked up to the wall, the opposite leg, which protrudes from the wall at a ninety-degree angle, supports the shelf. The length of the protruding leg have to be at the least -thirds of the depth of the shelf. For example, if the desired shelf is 12 inches deep, the supporting legs of the bracket should be at the least eight inches. Usually, both legs of the brackets are the same size; however this is just not a hard rule.

Step 2

Select the number of brackets to make use of for the shelf. If the brackets are spaced too far apart, the shelf will sag. A good rule of thumb is to put a bracket each sixteen inches. Place one at each end of the shelf, 1 inch from the outside edge, and every sixteen inches along the shelf length.

Step 3

Mark the wall, with the self-erasing marker, on the position of the underneathside of the shelf. Measure the gap from the floor to this mark. The ninety-degree angle of the bracket can be aligned with this mark. The shelf will sit on the legs of the brackets that protrude from the wall at this mark. Mark the wall, measuring up from the floor, at sixteen-inch increments, one location marker for every bracket and one mark for each of the tip brackets.

Step 4

Install the brackets onto the wall on the indicated bracket areas, following the manufacturer’s directions for attaching the brackets to the wall.

Step 5

Place the shelf, centered, on high of the brackets and insert screws up by means of the brackets into the bottom of the shelf to secure it into position. It’s helpful to pre-drill the screw holes to forestall a wood shelf from splitting.

If you have any type of questions pertaining to where and the best ways to make use of Heavy Duty Shelf Brackets, you can contact us at our page.